Wire Feed Welder Manual - Solar 2150

Infinitely adjustable from 50 to 700 inches per minute, accommodating wire diameters of .024, .030, and .035 inches. Control Interface:

Elias cursed, reset the breaker, and tried again. Same result. He checked the tension on the drive rolls. He checked the ground clamp. He swapped the contact tip. Nothing. The machine simply would not feed wire, and when it tried, it sounded like it was dying. solar 2150 wire feed welder manual

| Material Thickness | Voltage Setting (Dial Letter) | Wire Speed (Knob 1-10) | Wire Type | Gas | | --- | --- | --- | --- | --- | | 22 gauge (0.8mm) | A | 3 | .023 Solid | C25 | | 18 gauge (1.2mm) | B | 4.5 | .023 Solid | C25 | | 16 gauge (1.5mm) | C | 5 | .030 Solid | C25 | | 1/8" (3mm) | D | 6 | .030 Flux | None | | 3/16" (4.8mm) | E | 7 | .035 Flux | None | | 1/4" (6mm) (Multi-pass) | F | 8 | .035 Flux | None | Infinitely adjustable from 50 to 700 inches per

"Now," Miller continued, "Turn your wire feed speed knob down to about 3. The Solar 2150 has a massive inductance in its transformer. It runs 'hot.' If you set it like a Lincoln, you'll blow holes through everything. The manual says to start low and ease into it." He checked the tension on the drive rolls