Useful for closed-loop control systems like maintaining pressure in pumps or temperature in fans. Multi-Step Speed Control:
Model Number: CHE100-0R7G-S2Rated Power: 0.75 kW (1.0 HP)Input Voltage: Single-phase 220V AC (±15%)Output Voltage: Three-phase 0–220V ACRated Current: 4.0AControl Mode: Sensorless Vector Control (SVC) or V/f ControlProtection Rating: IP20 Installation and Environment Guidelines
By following this manual guide, you can ensure a stable and efficient setup for your INVT CHE100-0R7G-S2. For complex automation logic or Modbus communication setups, refer to the full manufacturer PDF for advanced parameter mapping.
| Interval | Action | | :--- | :--- | | | Check LED display for faults; listen for unusual noise from cooling fan. | | Monthly | Clean dust from heatsink using compressed air; tighten main circuit terminals (R, T, U, V, W) to specified torque (1.2 N·m per manual). | | Annually | Measure DC bus voltage (if qualified); replace cooling fan if bearing noise is present; check control terminal screw tightness. | | 5 Years | Replace DC bus capacitors (electrolytic capacitors dry out). Contact INVT service. |
Includes analog inputs (AI), digital inputs (DI), and relay outputs (NO/NC).
Useful for closed-loop control systems like maintaining pressure in pumps or temperature in fans. Multi-Step Speed Control:
Model Number: CHE100-0R7G-S2Rated Power: 0.75 kW (1.0 HP)Input Voltage: Single-phase 220V AC (±15%)Output Voltage: Three-phase 0–220V ACRated Current: 4.0AControl Mode: Sensorless Vector Control (SVC) or V/f ControlProtection Rating: IP20 Installation and Environment Guidelines invt che100-0r7g-s2 manual
By following this manual guide, you can ensure a stable and efficient setup for your INVT CHE100-0R7G-S2. For complex automation logic or Modbus communication setups, refer to the full manufacturer PDF for advanced parameter mapping. | Interval | Action | | :--- |
| Interval | Action | | :--- | :--- | | | Check LED display for faults; listen for unusual noise from cooling fan. | | Monthly | Clean dust from heatsink using compressed air; tighten main circuit terminals (R, T, U, V, W) to specified torque (1.2 N·m per manual). | | Annually | Measure DC bus voltage (if qualified); replace cooling fan if bearing noise is present; check control terminal screw tightness. | | 5 Years | Replace DC bus capacitors (electrolytic capacitors dry out). Contact INVT service. | | | 5 Years | Replace DC bus
Includes analog inputs (AI), digital inputs (DI), and relay outputs (NO/NC).
